Austenitic
Duplex Steel
Nickel Alloy
Cobalt Alloy

 ASTM A790 SAF 2507 Duplex Pipe Higher Yield With Annealing And Pickling

    MTSCO is specialized in duplex steel pipes produce . So we know good at duplex steel knowledge . Hope the clients who are choose us can be very assured . And no need worry about our produce ability. We , MTSCO , is worth for your belived .

    Most of 2507 duplex steel pipes are produced by cold drawn method . The alloy has higher yield

strength and lower ductility than austenitic steels so fabricators may fid that higher forming forces , increased radius of bending , and increased allowance for springback are necessary . Deep drawing , stretch forming , and similar processes are more difficult to perform on 2507 than on an austenitic

stainless steel . When forming requires more than 10% cold deformation , a solution anneal and quench

are recommended . And finished cold drawn duplex steel pipe , manufacturer should be solution annealed and quenched . The minimum annealing tempeture is 19250F . Annealing should be followed immediately by a rapid air or water quench. To obtain maximum corrosion resistance, heat treated products should be pickled and rinsed .

   SAF 2507 is a super duplex stainless steel with 25% chromium, 4% molybdenum, 7% nickel . This kind of pipes always purchased by the clients who are require exceptional strength and corrosion resistance .

   The steel has excellent resistance to chloride stress corrosion cracking, high thermal conductivity and a low coefficient of thermal expansion. And the high chromium, molybdenum, and nitrogen levels provide excellent resistance to pitting, crevice, and general corrosion.

     Welcome everyone who need this kind of pipes contact to me in free . Also MTSCO can produce stainless steel seamless pipes, bright annealed tubes, seamless coiled tubing etc . You go ahead one step , we can help you creat more profits than your mind .